Plasma Cutting Tips
What You Should Do Before Using Your Plasma Cutter
Having purchased the best plasma cutter, the first thing that you have to do is to read its owner's manual. You can learn more about the cutter that you have purchased. It is very important to read the manual simply because it contains information about safety as well as provide you with an insight on how you can get the most out of the plasma cutter you have purchased.
After you have finished reading through the owner's manual, it will help to also get some tips regarding how to use the plasma cutter. You might even have to do some “pre-flight” routine so that you can make sure that you are plasma cutting the right way. This routine is what you have to do before you actually plasma cut the metal. Here are the things you should do as part of your “pre-flight” routine.
First, you have to check your power cord. Make sure it is in good condition. It is also your job to ensure that the power cord is actually plugged into the right type of power supply. There are units that can be plugged into power supply from 208 to 575 volts. On the other hand, there are also those units that should only be plugged to a specific voltage. Following the instructions regarding the voltage of the power supply will prevent damaging the plasma cutter.
The air supply should also be checked. This is so that you can get an assurance that you will be able to utilize the correct air flow and air pressure when you are using your plasma cutting machine. You should not overlook the information regarding the air requirements of your plasma cutting machine in the owner's manual.
Take note that dry air is vital for plasma cutting. It is what maximizes the cutting capacity of the plasma cutting machine, after all. You might want to install an air filter then or a dryer on your machine if it is not equipped with any of that. Maintain, check, and replace the dryer or filter as recommended by the manufacturer. Also, do not forget to apply a sealant to the connection to avoid air pressure leak.
Connect the torch. You need the torch to work on your plasma cutting project. Connect it if it is not yet connected at this point.
The consumables should be collected as reserves and placed at the right spot that offers convenient access. They should be the correct ones you are using for this particular plasma cutting job. The consumables that you have fitted into your plasma cutter should also be secure and snug. Avoid over-tightening the drag cup since you will be experiencing intermittent cuts with that.
The air setting should also be checked. You should know that PSI setting may be different for gouging and cutting. Learn how to choose an air setting as well as how to make adjustments for the type of material you are using for the plasma cutting work.
Set the output of your machine to the right setting. It will certainly improve the performance and cut of your plasma cutting machine if The air setting should also be checked. You should know that PSI setting may be different for gouging and cutting. Learn how to choose an air setting as well as how to make adjustments for the type of material you are using for the plasma cutting work.
Set the output of your machine to the right setting. It will certainly improve the performance and cut of your plasma cutting machine